Accessories for electronic locks

Latch 74

The LATCH74 is used as a counterpart of the SOLO and TEN. It is mounted on the side of hinged doors, drawers or on the upper web of drawers.

  • Adjustable in height / width / depth
  • Automatic adjustment +/- 2 mm
  • Ejector with 5.4 N spring force
  • Breaking point of 35 kg

A handle-free opening of doors and light drawers without a tumbler is possible.

Article no:Properties:Colour:
LATCH743D adjustableBlack

Latch 75

The LATCH75 is a frontal counterpart. It is mainly used for sliding doors in combination of the SOLO, TEN, and BEETLE or when the SOLO or BEETLE is mounted on the carcass of the furniture.

  • Automatic adjustment +/- 2 mm
  • Breaking point of 35 kg
  • Adjustable in one direction when mounting
Article no:Properties:Colour:
LATCH75Locking part adjustableBlack

Battery CR 123A

The BATTERY CR123A is used to power the electronic furniture locks of the following product families:

SOLO, TWO, TEN, PLUR, ONE and PAD.

When the end of the battery life is reached, a continuous tone of 15 seconds sounds when the furniture is opened, and the lock does not lock anymore.
The TEN lock shows a LED light signal and the lock does not lock after opening.

  • Do not use in combination with an external power supply
  • Lifespan:

125 KHz: 5-9 years
13.56 MHz: 4-6 years
Bluetooth: 3-4 years

In continuous operation, a battery works up to 35,000 cycles.
It is advisable to replace the battery every three years.

Article no:Properties:Capacity:
BATTERY CR123ALithium metal battery1600 mAH

Glass mounting kit

The GLASSKIT is used for mounting on glass furniture in combination with the product family SOLO.

Breaking point:

  • Up to 45 kg with hinged doors
  • Up to 25 kg with sliding doors

The assembly takes place directly on the cleaned glass surface through the supplied adhesive tape. The cover film is attached to the outside.

Article no:Properties:Colour:
GLASSKITFor fastening SOLO locks on glassBlack

Metal mounting kit

The METALKIT is used for mounting on metal furniture in combination with the product family SOLO.

  • Punching out the metal: 42×42 cm

The supplied screws are suitable for metal thicknesses of 0.5-2mm to screw the cover plate to the lock.

Article no:Properties:Colour:
METALKITFor fastening SOLO locks through metal doorsBlack

Programming card

The programming card is used to activate and deactivate RFID keys.

  • A programming card can be used for countless locks
  • The programming card is activated by pressing the button on the back of the lock (see programming instructions)
  • Only one programming card per lock can be active
Article no:Compatible with:RANGE:
PROCARD 125All 125 KHz locks< 35 mm
PROCARD 13All 13.56 MHz locks< 25 mm

Key card

The KEYCARD is used as a key for RFID locks.

  • Water resistant
  • Credit card format
Article no:Compatible with:RANGE:
KEYCARD 125All 125 KHz locks​< 35 mm
KEYCARD 13All 13.56 MHz locks​< 25 mm

Key fob D

This KEYFOB D is used as a key for 125 KHz locks.

  • Water resistant
  • Metal frame
  • Colour: black and shiny
Article no:Compatible with:RANGE:
KEYFOB 125 DAll 125 KHz locks​​< 25 mm

Key fob

The KEYFOB is used as a key for RFID locks.

  • Water resistant
  • Colour: black and white
Article no:Compatible with:RANGE:
KEYFOB 125All 125 KHz locks​​​< 25 mm
KEYFOB 13All 13,56 MHz locks< 15 mm

Bracelet

The bracelet is used as a key for RFID locks.

  • Water resistant
  • Bracelet with RFID chip black and white
  • Buckles closure
Article no:Compatible with:RANGE:
WRISTBAND 125All 125 KHz locks< 25 mm
WRISTBAND 13All 13,56 MHz locks< 15 mm

RFID sticker

The KEYSTICKER 125 is used as a key in the 125 KHz locks. These RFID stickers can be attached to existing cards or HMI devices.

Features:

  • Are particularly suitable for mounting on plastic
  • 3M 0.3 mm thick adhesive film on the back
  • Round version: 30 mm Ø
  • Rectangular version: 30×19 mm
  • Different sizes on request
Article no:Compatible with:RANGE:
KEYSTICKER 125 30x19All 125 KHz locks, black mat< 20 mm
KEYSTICKER 125 30WAll 125 KHz locks, round white< 25 mm
KEYSTICKER 125 30SAll 125 KHz locks, round black< 25 mm

External antenna 125

If the SOLO or PLUR lock with 125 KHz is difficult to access, this antenna is plugged into the lock to simplify the application.

  • Wooden furniture: not visible from the outside, mounted on the inside
  • Metal furniture: visible from the outside
  • Cable length: 1.5 m
  • EM4102 / EM4200 RFID technology
Article no:Compatible with:RANGE:
ANTENNA 125All 125 KHz locks, black mat< 20 mm

External power supply

The power supply is a direct power supply for the SOLO and PLUR lock and is connected with a 1.5 m long cable at the back of the lock.

  • EU plug 220V
  • US plug 110V
  • Do not use in combination with batteries
  • Up to 5 connected locks can be operated with one transformer

In combination with the SOLO lock, a spacer plate is suitable.

Article no:Compatible with:PLUG:
PSUPPLY 125SOLO 125, SOLO BT, PLUR 125 and PLUR BTEU
PSUPPLY 13SOLO 13 and PLUR 13EU
PSUPPLY 125 USSOLO 125, SOLO BT, PLUR 125 and PLUR BTUS
PSUPPLY 13 USSOLO 13 and PLUR 13​US

Spacer plate

The spacer plate protects the cables when a SOLO is used with a transformer, SOLO slave or external antenna.

Article no:Compatible with:Colour:
DISTANCEPLATESOLOBlack

Connection cable

The connection cable serves as a connection between SOLO and SOLO SLAVE locks. 

Article no:Compatible with:CABLE LENGTH:
CONCABLE 1,5SOLO1,5 m (60 '')
CONCABLE 3SOLO3 m (120 '')
CONCABLE 5SOLO5 m (195 '')
CONCABLE 10SOLO10 m (390 '')

Battery AAA

The BATTERIES AAA are used to power the GYM or the QUAD furniture locks.

When the end of battery life is reached, a continuous tone of 15 seconds sounds when the furniture is opened. The lock does not lock anymore from that moment on.

  • Do not use in combination with an external power supply
  • Lifespan:

125 KHz: 5-9 years
13.56 MHz: 4-6 years
Bluetooth: 3-4 years

In continuous operation, the batteries work up to 25,000 cycles.
It is advisable to change the batteries every three years.

Article no:Properties:Capacity:
BATTERY AAALithium Ion Battery1250 mAH

Latch 70

The LATCH70 serves as a mini counterpart for the BEETLE lock. It is mostly used in glass showcases or in very small drawers.

  • The closing part has no tolerances which is why a very precise processing of the furniture is necessary
  • UV adhesive glue is suitable for attachment to the glass. This is not included.
Article no:Properties:Colour:
LATCH70Mini locking partStainless steel

Extension board

The plug-in distributor is a slot extension in applications such as the SOLO with SOLO slave locks. It is also used when several BEETLE slave locks are operated together.

Article no:Compatible with:SLOTS:
EXTENSION BOARDSOLO / Beetle9

Update: Gym

With the free locker choice, you can occupy lockers with your RFID key to any unused cabinet. Only that key or the programming card can reopen this cabinet. After opening, the cabinet can be occupied by any other keys.

Features:

  • Ideal for use in public areas, gyms or staff cabinets
  • The cabinet can only be occupied when the door is closed
  • With one card several cabinets can be occupied
  • The lock does not need writing permission on the map. Only the UID number of the card is read
  • When not installed, the lock can be tested with the locking part inserted
Article no:Compatible with:OPENS AUTOMATIC:
UPDATE GYMSOLO 125 + / SOLO 13 +Never
UPDATE GYM 12hSOLO 125 + / SOLO 13 +After 12 hours

Update: Alarm

If the furniture is not closed within 25 seconds, a continuous tone sounds as an alarm.

Applications:

  • Ideal for securing merchandise in shops
  • Securing medicines and spirits

The alarm can be deactivated by RFID key or closing the door.

Article no:Compatible with:ALARM:
UPDATE ALARMSOLO 125+ / SOLO 13+Ticking noise

Update: Bolt

With this update, the lock does not lock automatically after 3 seconds but remains open until the key is held on again.

When using several locks in a group (wired), this function may only be used with an external power supply.

Article no:Compatible with:FREQUENCIES:
UPDATE BOLTSOLO, GYM, PLUR, TWO, ONE125 KHz/ 13 MHz
Close Menu